徳島大学 教育・研究者情報データベース(EDB)

1. (英) Okada Ryo / (日) 岡田 涼 / (読) おかだ りょう

   役割	任意
   貢献度	任意
   学籍番号	推奨	****

2. 酒井 紀典([徳島大学.病院.中央診療施設等.高度先進整形外科診療部])

   役割	任意
   貢献度	任意
   学籍番号	推奨

3. 西庄 俊彦([徳島大学.大学院医歯薬学研究部.医学域.連携研究部門(医学域).寄附講座系(医学域).脊椎関節機能再建外科学])

   役割	任意
   貢献度	任意
   学籍番号	推奨

4. (英) Nitta Akihiro / (日) 新田 晃弘 / (読) にった あきひろ

   役割	任意
   貢献度	任意
   学籍番号	推奨	****

5. (英) Takahara Shigeyuki / (日) 高原 茂之

   役割	任意
   貢献度	任意
   学籍番号	推奨

6. (英) Oba Koichi / (日) 大歯 浩一

   役割	任意
   貢献度	任意
   学籍番号	推奨

7. 西良 浩一([徳島大学.大学院医歯薬学研究部.医学域.医科学部門.外科系.運動機能外科学])

   役割	任意
   貢献度	任意
   学籍番号	推奨

(英) Preoperative Planning Using Three-dimensional Printing for Full-endoscopic Spine Surgery: A Technical Note.

(英) Transforaminal full-endoscopic spine surgery (TF-FESS) is a novel minimally invasive spine surgery that requires only an 8-mm skin incision and causes minimal damage to the paravertebral muscles. To perform TF-FESS safely and efficiently, preoperative planning is quite important as the intervention requires anatomical understanding and high technical skills. Recently, three-dimensional (3D) printing has become a useful tool in various surgeries, and several studies have addressed its efficacy; however, there are no reports on the application of 3D printing to FESS. In this study, we present two cases of severe lumbar deformities for which preoperative 3D printing was useful. The 3D printing enabled the surgeons to visualize and plan the drilling of the superior articular process for a successful foraminoplasty at a low cost. The manufacturing equipment cost about USD 900 and is able to produce an actual-size model at a cost of less than USD 10 per patient. In conclusion, preoperative planning using 3D printing should be adopted to safely perform FESS.

1. (英) PublicationType: Case Reports